Classy and robust full-grain leather with slight sanding to create the characteristic velvet appearance. Depending on the required finish, Nubuk can be waxed, brushed or left untreated.
Velours leather, or suede leather, is obtained by an internal split of the hide/skin. Thanks to its rough surface structure it is highly abrasion resistant and breathable. Depending on the required finish, Velours leather can be waxed or left untreated.
Calf Sports Leather
Typically, extremely thick fullgrain leather with smooth finish on external grain side. This makes this kind of leather very robust. Depending on the required finish, calf sports leather can be waxed,brushed or left untreated.
Idro-Perwanger® Leather 3.0 / 2.4 mm
Extremely thick full-grain leather made by the south tirolian high quality tannery Perwanger®, with rough grained finish on external flesh side. This makes this kind of leather very abrasion resistant and robust. Depending on the required finish, leather can be waxed, brushed or left untreated.
Fine-grained leather with an exterior protected by a coat of polyurethane to make it even more abrasion-resistant, tear-resistant and waterproof.
This synthetic leather is hard to tell apart from genuine nubuck leather, except that it’s lighter and absorbs very little water.
This roughly woven Italian textile of 73% polyamide and 27% polyester is very light, extremely resistant to abrasion and rip-proof. Permanent waterproofing prevents excessive water absorption.
The Kevlar filaments integrated evenly over the PA base fabric provide effective protection from sharp stones or branches. The fabric is also very light and fast drying.
Liquid Rubber Protection
Zones featuring Liquid Rubber reinforcements safeguard the footwear against abrasion and damage. This rubber is applied when wet and is lighter than conventional rubber rands.
This synthetic leather was developed for motorcycle racing; thanks to its microfiber structure it is three times lighter than leather of the same thickness, extremely resistant to abrasion and hardly absorbs any water.
The Soft Shell textile worked into Mammut shoes is tailored for robust footgear, abrasion resistant and waterproof, without compromising its positive Soft Shell characteristics (excellent breathability,wind-proof, water-resistant,expandability).
Light, opencell Polyamid mesh with good abrasion results. The Vent mesh has a high breathability and a superb rip strength.
This networked air-mesh weave of robust polyamide achieves maximum ventilation while retaining a stable form.
Constructed from a blend of supple inner and tough outer materials, which means the boot is hard only where necessary and can be designed to fit the foot for enhanced comfort.
Single Shell Construction
This aim of this type of construction is to create the shaft of a shoe using a material with as few seams as possible. This provides greater robustness, thanks to the lower number of contact surfaces and reduced overall weight.
The extremely robust, abrasion-resistant, UV and moisture-resistant polyethylene fiber used has an aesthetic, high-quality appearance and represents real innovation in the functional footwear arena. It is 60% more abrasion resistant than carbon fiber of the same thickness, and around 15 times stronger than steel.
2 Tone PA
The two differently structured polyamide yarns each have different abrasion and tear resistance in one direction, resulting in a technically functional and very visually attractive fabric.